The advantages of castables for ladle lining:
Short construction period, improve the turnover rate of equipment.
Mechanized construction, less physical exertion, more humane.
Longer and safer service life, less accidents.
A uniform structural design, no joints, without structural weaknesses.
Can be repaired repeatedly, reducing the refractory consumption and the problems of waste lining disposal.
Better lining design, lower heat conductivity and save energy.
It can be used to make different linings according to each material’s property.
It can be used to make precast shapes according to specific requirements.
Short delivery times, reducing inventory and capital pressure.
Metal and slag are usually bonded to the wall.
Cleaning the slag will not only waste a lot of labor and time, but also will cause damage to the work lining. The application of coating material can help to reduce de-slag frequency:
Reduce the labor cost;
Reduce mechanical wear and impact on the lining;
Extend the service life of the lining.
|ULTRA-FLO 85||Alumina based low cement castable||84.0||12.0||2.0||2.85||1750|
|ULTRA-FLO 84||Alumina based low cement castable||80.0||14.0||1.5||2.70||1700|
|ULTRA-FLO 61||Malayan low cement castable||63.0||30.0||1.5||2.50||1700|
|ULTRA-FLO 51||Gem-based low cement castable||48.0||45.0||1.2||2.30||1650|
|ULTRA-FLO 49||Gem-based low cement castable||46.0||48.0||1.6||2.32||1650|
|ALU-FLO 81||Acacia high flowability castable||80.0||15.0||2.0||2.90||1700|
|ALU-PAK® 55||Aluminum silicon based plastic||62.0||32.0||2.55||1680|
|ALU-PAK® 67||Aluminum silicon based plastic||68.0||26.0||2.65||1700|
|ALU-SEAL 68||Aluminum silicon based plastic||68.0||26.0||2.65||1650|
corundum-based plastic material
|MAG-SEAL 813||Magnesium oxide based anti-stick coating||25||56（MgO）||2.0||1650|
|LADLE SEAL||Carbon silicon based coating||11.0||65.0||20（C）||1.80||1650|