Anti-slag coating manufacturers take you to understand how carbon ramming materials are constructed

Anti-slag coating manufacturers tell you that the construction of carbon ramming materials is mainly based on ramming methods, but the construction methods of different parts of use and construction body structures will also be different.

Anti-slag coating manufacturers tell you that the construction of carbon ramming material at the bottom of the blast furnace should wait for the control flat steel to be installed and inspected before starting the ramming construction. In order to prevent damage to the leveling flat steel, the ramming material must be evenly distributed during construction Spread it in the leveling flat steel belt, use a plate vibration tamper, and ram back and forth along the space between the steel belts until it is dense.
The rammed surface must be shaved first, and then add a layer of material to continue ramming. The thickness of each layer is 100mm. After 2-3 times of feeding and continuous ramming, it can be compacted.
The anti-slag coating manufacturer tells you that the carbon ramming material after the final ramming must be higher than the top surface of the flat steel, and finally level the top surface of the steel strip with a scraper one by one, and use a spirit level to check whether it is on a horizontal plane. The next step of carbon brick masonry can be carried out after the test meets the standard.
Strictly follow the construction instructions of carbon ramming material for construction. During construction, the four corners and other edge parts should be rammed and compacted to avoid poor thermal conductivity and erosion.
The above is the whole content of how the carbon ramming material is constructed by the Anti-slag coating manufacturer. I hope it can be helpful to you.